Luckily it's the Q key so you just need to slide your finger across to hold Q and W at the same time. As it starts to level off at the top, you need to lower it at the same rate, and then repeat this method but with the front (so raise the front as you go down, then lower it as you get onto the road).ĭon't forget to keep an eye on your pressure gauge, though! I blew the fuses halfway down the descending ramp (it didn't topple though - phew!), but letting it get high will stress you out more. As you hit the ramp you need to raise the rear up in time with the increasing slope - it doesn't need to be perfect but you want to stay within ~1% of the ramp slope (so if it says +2.5% you need to be over +1.5% at the rear and no more than +3.5%), which is fairly easy if you just keep lightly tapping the raise key as you go up. I found it a little easier to raise the rear and front up a little before moving, but you do need it to be slightly higher at the rear to start with.
Use the first flat run to get the crawler lined up with the ramp, and you then need to keep going without stopping. Any stopping and starting almost always toppled the shuttle. Originally posted by monsted:I found the best way to keep it from falling over was to keep the accelerator down all the time and just adjust the angle of the platform as needed as i move.
0 kommentar(er)
